On 6/26/2012 3:47 PM, Ade Lee wrote:
Please review.
Tests done: 1. Cert issuance and approval from UI (manual, maul dual cert, agent authenticated server cert) 2. Cert issuance in installation of other subsystems 3. Cert issuance (user and server) from RA. 4. Cert issuance and approval from restful interface using CATest -- two step (create cert request/ agent approval) user and server certs -- single step (agent approved user and server certs)
Some comments, more to follow. Some of these might have been discussed previously. 1. Some fields in the ProfileProcessor are initialized to null in the field declaration. This is not necessary because it's null by default. 2. The code in ProfileProcessor.java:1450 might fail because statEvents could still be null if an error happens before the first startTiming() is called. It might be better to initialize statEvents in the field declaration instead of in startTiming(). Alternatively, it's possible to track the timing without statEvents using a separate try-finally block for each startTiming() & and endTiming() pair: startTiming("enrollment"); try { ... startTiming("request_population"); try { ... } finally { endTiming("request_population"); } ... } finally { endTiming("enrollment"); } 3. Not sure if this is a problem. In ProfileProcessor.java:721 the errorCode is initialized to null before the loop. Inside the loop the errorCode is set when there's an exception but never reset to null again. So if one request fails and the next one succeeds it will still have the errorCode of the previous failure. The errorCode determines whether to call markAsServiced() or updateRequest(). The original servlet has the same behavior. 4. The serial_num in ProfileProcessor.java:412 seems to be used for renewal only. It might be better to move it into processRenewal(). 5. In ProfileProcessor the ps.getProfile() is called multiple times to get the profile. Usually it's using the profileId specified in the request (line 415) but it can be overriden by the configuration (lines 460 & 555). However, the profile inputs are always obtained from the profile specified in the request (line 417). So it's possible the inputs won't match the profile. It might be better to check the configuration when creating the EnrollmentRequestData then subsequent code will use the one specified in it. -- Endi S. Dewata